Silicone Potting A+B ratio 1:1 for LED Drivers

INTRODUCTION
        Silicone Potting A+B ratio 1:1 for LED Drivers is two-component silicone thermal conductive and flame retardant potting adhesive. It is a new type of thermal conductive insulation material synthesized with silicone. It has the characteristics of no heat release, no corrosion and small shrinkage when curing. It is suitable for various thermal conductive sealing and pouring of electronic components to form a thermal conductive insulation system.


APPLICATION
- Perfect for LED drivers potting

- High power electronic components

-Encapsulation protection of module power supply and circuit board with high requirements of heat dissipation and temperature resistance



ADVANTAGES
* Flame retardant, UL94-hb to UL94-V0 grade.

* Suitable for various thermal conductive sealing and pouring of electronic components to form a thermal conductive insulation system.

* Low viscosity, fluidity, self foaming, more convenient pouring complex electronic components, can be poured to the minute.

* The sealed components can be taken out for repair and replacement, and then the potting glue can be used for repair without leaving traces.

* The compound can be stored for a long time after mixing at room temperature, but it can be cured quickly under heating conditions, which is conducive to the use of automatic production line.

* curing process does not shrink, has better waterproof, moisture and anti-aging performance.

This is not only the characteristic of potting glue, but also the characteristic of silicone rubber itself can be used in production and life. For example, it has good acid-base resistance, atmospheric aging resistance, insulation, compression resistance, moisture resistance and shock resistance.