Bronzing gel plates is how to make it?

Bronzing gel moderators for Schomburg plastic toys, gifts, hardware, electronics, specialty products and printing industry, high temperature, thermal transfer new material, special high temperature products, hot plates, hot stamping silicone roller, heat transfer, etc. products. And now, at present, in the etching process using photographic and computer engraving technology premise, coupled with silica gel plates bonded aluminum can produce photographic etching process and bronzing gel plates. 　　So how hot stamping silicone plate is produced? 　　an open two wash three fill four cut 　　A good first first open mold (can be Lu, iron mold or mold), up and down like a box that can be put together, surrounded by flat lower die mold open a 2 mm wide exhaust ducts to the process of pressure help rid the mold in the air. 　　Before brushing second layer inside the silicone mold release agent (either Vaseline or detergent), first clean the entire mold mold, such as mold dries then the following operations. 　　The third and most crucial step in the bottom of the mold at the top of the piece of aluminum is best marked with holes, or sanding paper with roving about, in order to enhance adhesion of silica and aluminum filled aluminum, the aluminum in place, aluminum also to clean the adhesive coated on a clean aluminum. The aluminum can is filled with multi-block, the real work is the top piece. Silica gel plates and molds and aluminum cutting area is slightly smaller, to the internal width of the width of the mold in order to stay more than two centimeters of material between the gas can be discharged. This can prevent swelling after molding. In fact, in order to increase the adhesion between the silicone and aluminum. At the top piece of aluminum can be painted above the water to get to heaven, 　　The fourth cut the silicone, aluminum four weeks to choose a small one cm silica gel plates, because the process of repression, silicone extension will be like four weeks. Then the silica gel plates slowly spread from one end to the aluminum up, then stick on silica gel plates make a head rolled from one end. To do so is to head to catch the air. Pressed between doing good silicone and aluminum would be no air, no air bubbles, bonding would be better. The mold pressed to get on the molding machine, mold die while in the second row to three times the gas, if the molding machine with vacuum machines have the same exhaust vacuum pump 30 seconds. Finally, under ten tons of pressure and temperature 160-250 20-30 minutes after pulling the mold, remove the gilt plate normal cooling at room temperature. 　　Do you  want to learn more? You can click on the company official website: http://www.szrl.net or  consultant :400 -779-4008, you can also e-mail us info@szrl.net, leaves Jay professional answers to your doubts.